30
Operating Instructions 10/2020 2010045v10
If changes are made to the parameters on the
following pages, this is indicated in the lower third
of this screen. You must accept or discard these
changes via the corresponding buttons so that they
are stored in a fail-safe manner. Some parameters
require a restart of the charging station to be
activated.
7.2.1 Local authorization list (whitelist) with RFID card
Charging requires a locally stored RFID card for authorization. The charging process is terminated by
presenting the same RFID card in front of the card reader.
The RFID functionality allows you to limit user
access to the charging functionality of the charging
station. Users identify themselves using an RFID
card on the charging station's RFID card reader.
When the selected authorization method releases
the user, a charging process can be started.
In the "RFID Reader" area, you can add RFID cards
that have already been read to an internal (local)
whitelist or remove them from this list. This is an
OCPP-independent list (see Authorization
Methods).
You can also delete the entire internal (local)
whitelist.
Furthermore, it is possible to use a master list. RFID
cards that are assigned to this list can end a
charging process at any time. To do this, the
corresponding charging point must be selected for
display in charging mode.
Fig 30: Accepting/rejecting the parameter
changes
To Next Page
Loading...