3-74 BA 348-01 * 2.0 * 34801b340.fm
3 Operation
Fitting a standard bucket onto the quickhitch
12
Re-equipping the attachments is described below for the standard bucket. If you are fitting
or removing attachments with their own hydraulic functions – multipurpose bucket or rotary
broom, for example – you must follow the special information given in the Operator’s Manual
of the attachment.
Before starting work, ensure that the attachment is safely locked onto the
quickhitch by means of the lock ram.
☞You must be able to see lock pin G (circle) on either side in the mounting
bores on the attachment
Picking up a standard bucket
☞Approach the wheel loader to the attachment
☞Lower the loader unit. To do this: push control lever 11 forward C and
☞Tilt the quickhitch forward. To do this: push control lever 11 to the right B
☞Raise the loader unit until the quickhitch engages in the hooks of the attachment
➥Pull control lever 11 backward D
☞Tilt in the quickhitch completely
➥Push control lever 11 to the left A
Locking/securing a standard bucket
Secure the attachment with lock pins G of the quickhitch. To do this:
☞Pull control lever 12 backward Z
➥Lock pin G engages in the mounting bores of the attachment
☞During machine travel on public roads, secure the control lever of the 3rd control circuit
➥–seeOperating and securing the 3rd control circuit (standard) on page 3-65
SKID STEER
Fig. 98 : Attachment on quickhitch
G
12
O
Z
G
G
A
B
C
D
11
To Next Page
Loading...
