3-80 BA 348-01 * 2.0 * 34801b340.fm
3 Operation
Loading if the material is hard to penetrate
☞Loading if the material is hard to penetrate
• As for loading loose material, but in addition:
• Tilt the bucket in and out a little. To do this: move the control lever to the left and right
A and B
When the bucket is full:
• Tilt in the bucket C. To do this: push the control lever to the left A
• Reduce engine speed
• Reverse out of the material
• Raise the bucket to transport position B
Fig. 106 : Loading if the material is hard to penetrate
B
A
Fig. 107 : Tilting in the bucket
C
A
B
To Next Page
Loading...
