BA 348-01 * 2.0 * 34801b330.fm 3-45
Operation 3
3.24 Wheel synchronization
The steering system has to be synchronized if the wheels on both axles do not run in the
same track when travelling in a straight line!
Risk of accidents! Do not synchronize the wheels when driving the machine,
neither off-road nor on public roads!
☞Synchronize the steering system before putting the machine into operation
☞At low travel speed, slowly turn the steering wheel to the left and right as far as it will
go and try turning it even further in the end position for a few seconds (as for cornering)
☞Turn the steering wheel rapidly back to straight-ahead position
➥The wheels of the front and rear axles must now run in the same tracks
Contact your dealer if this does not synchronize the wheels
3.25 Accelerator pedal
Speed control with the accelerator pedal
Accelerator pedal 6 controls the travel speed as follows:
If the accelerator is completely released, the drive immediately brakes
hydrostatically and the machine is braked to a stop!
Accelerator pedal Function
• Press down ➥Travel speed is increased
• Release slowly ➥Travel speed is reduced
• Release fully ➥Hydrostatic braking
To Next Page
Loading...
