BA 348-01 * 2.0 * 34801b330.fm 3-39
Operation 3
3.22 Preparatory work – putting the machine into operation
Notices on putting into operation
• Keep the pedal area clean
• Carrying or transporting accompanying persons in the cabin or on the machine is
prohibited
• Driving or operating the wheel loader outside the operator’s compartment is prohibited!
Put the machine into operation only when seated
• Observe the applicable national regulations, for example StVZO (German traffic
regulations), the National Type Approval (Germany) or the Data Confirmation
(Germany)
• Only the attachments are certified for use on public roads that are described in the
National Type Approval (Germany), in the Data Confirmation (Germany) or in this
Operator’s Manual
“Certified attachments” on page 1-13 (the footnotes must be taken into account)
• In trailer operation the provisions laid down in the National Type Approval (Germany),
or the Data Confirmation (Germany) must be observed – also see “Trailer couplings
(option)” on page 3-111
• Bear in mind the trailer and drawbar loads – see chapter 6 “Trailer weight/drawbar
load: trailer couplings (option)” on page 6-13
• Adjust the correct seat position –seeOperator seat on page 3-17
• Fasten your seat belt –seeSeat belt (lap belt) on page 3-23
• Adjust the mirrors
In order to avoid risk of accidents, adjust the rearview mirrors ensuring good
visibility to the rear (rear part of machine)!
Risk of accidents! The towing gear at the rear of the machine is not certified
for trailer operation and may be used only for towing away the machine
(without drawbar load)!
When travelling downhill, the brake pedal (intermittent braking) must be
used for supporting the braking effect of the drive. This avoids damage
to the drive and the engine due to excessive speed. .
To Next Page
Loading...
