3-30 BA 348-01 * 2.0 * 34801b330.fm
3 Operation
Entering/changing the personal code
In order to enter or change the personal code:
☞Disable the drive interlock by entering the main code (6 digits) and pressing the (*) key
☞Turn the ignition key to position 1
➥The LED illuminates for 2 seconds
☞Enter the 4, 5 or 6-digit new personal code and confirm with the (*) key within 20 seconds
after the LED has gone out
☞Enter the new personal code again and confirm it with the (*) key after a short flashing
of the LED
➥Confirmation: LED flashes twice briefly, then illuminates for 2 seconds
☞Turn the ignition key to the 0 position and remove it as soon as the LED goes out
➥The new personal code is now set and can be used for disabling the drive interlock.
The personal code must be entered correctly twice consecutively otherwise an
error is indicated by means of a single flashing of the LED:
☞Codes consisting of 3 and less, or of more than 6 digits are ignored by the
system
☞Simple codes (with identical or consecutive digits, for example 1, 2, 3, 4)
are rejected by the system with four short acoustic signals
☞Entering a new personal codes replaces the previous code. A code can be
changed any time if the main code is known
Enabling the drive interlock
☞Stop the engine and remove the ignition key
➥The drive interlock is automatically enabled
➥Flashing LED (on the keypad)
To Next Page
Loading...
