BA 348-01 * 2.0 * 34801b340.fm 3-83
Operation 3
Loading heaped material (compacted material)
☞Proceed as follows:
• Proceed as for non-compacted material, however when raising the loader unit
through the heaped material, tilt the bucket slightly in and out (1).
To do this: move the control lever alternately to the left and right (A and B)
➥ The material is loosened
Practical hints for loading vehicles
• If possible, the truck and the working direction of the loader should form an angle of 45°
• Raise a full bucket only before the unloading position
• If possible load material with the wind behind you to keep the dust away from your
eyes, air filters and fans
Freeing the machine
Proceed as follows if the machine should get stuck when picking up material:
• Tilt out the bucket until the blade is vertical above the ground
• Lower the loader unit all the way
• Gradually tilt in the bucket
• The machine is pushed backward
• Reverse slowly
• Repeat this procedure until the wheels reach firm ground
• Reverse the machine away
Fig. 116 : Heaped compacted material
1
A B
Fig. 117 : Loading vehicles.
To Next Page
Loading...
