3-40 BA 348-01 * 2.0 * 34801b330.fm
3 Operation
Preparing for driving on public roads
☞Prepare to start the engine as follows:
• Remove attachments that are not authorized for transport on public roads
– see chapter 1 “Certified attachments” on page 1-13
• Empty and tilt in the bucket as far as it will go
• Raise the loader unit to transport position (ground clearance about 200 mm)
• Install the protection on the leading edge of the bucket
• Adjust the correct seat position –seeOperator seat on page 3-17
• Fasten your seat belt –seeSeat belt (lap belt) on page 3-23
• Adjust the mirrors
In order to avoid risk of accidents, adjust the rearview mirrors ensuring good
visibility to the rear (rear part of machine)!
• Switch off the working lights during machine travel on public roads
–seeWorking lights on page 3-58
• Switch on the load stabilizer –seeLoad stabilizer (option) on page 3-53
• Secure the control lever (joystick) and the 3rd control circuit of the loader unit
–seeLock for loader unit control lever and mechanical locking of 3rd control circuit
(standard) on page 3-42 or “Lock for loader unit control lever and electrical lock for
3rd control circuit lever (option)” on page 3-43
• Check all signalling and light systems for correct function
–seeMachine lights (option) on page 3-57 and “Signalling system” on page 3-59
• When using a trailer, ensure that the trailer is safely locked in the coupling jaw and
that the loads are firmly tied down on the trailer –seeTrailer couplings (option) on
page 3-111
Self-propelled work machines may not transport goods on public roads
with a trailer. Only the transport of machine’s own attachments is allowed!
Also refer to the National Type Approval (Germany), the Data Confirmation
(Germany) or the registration documents of the machine.
Get informed on and follow the legal regulations of your country.
To Next Page
Loading...
