3-88 BA 348-01 * 2.0 * 34801b340.fm
3 Operation
3.52 Working with the multipurpose bucket
Safety instructions on work operation
Caution! Bear in mind the safety instructions given in chapter 2 before working with the
machine!
• – see chapter 2 “Designated use and exemption from liability” on page 2-2
• – see chapter 2 “General conduct and safety instructions” on page 2-3
• – see chapter 2 “Safety instructions regarding operation” on page 2-6
• Caution, risk of fatal injury! When working with the machine, look out for high-voltage
cables, underground cables, gas and water pipes!
• Danger of collapse! Never drive up to the edge of a pit from outside, never undermine
the foundations of walls
• Bear in mind the mandatory regulations for accident prevention
• Secure the 3rd control circuit against unintentional operation
–seeFitting a standard bucket onto the quickhitch on page 3-74
• Do not perform any jerky movements with the control lever (joystick)
• Set down and pick up loads carefully at low diesel engine speed
• When loading with the machine, switch off the load stabilizer (option), as it will yield
very easily, making it difficult to perform any precise lifting movements
–seeLoad stabilizer (option) on page 3-53
• Caution! Before leaving the machine, lower the bucket to the ground, stop the diesel
engine, switch off ignition and remove the key
• In order to avoid risk of accidents, ensure that the attachment is safely locked onto the
quickhitch by means of the lock ram before starting work
➥You must be able to see the lock pins on either side of the mounting holes on the
attachment
Fig. 122 : Locking the attachment
To Next Page
Loading...
