BA 348-01 * 2.0 * 34801b330.fm 3-35
Operation 3
Preparing to start the engine
0
☞Run through the “Start-up” checklist 3-11
☞Switch on the battery master switch –seeBattery master switch (option) on page 3-25
☞
Sit down on the operator seat
☞Apply the parking brake
–seeParking brake on page 3-50
☞Adjust your seating position –seeOperator seat on page 3-17
➥ All controls must be within easy reach
➥ You must be able to move the brake and accelerator pedals to their limit positions
☞Adjust the rearview mirrors (you must be able to see the rear area of the machine)
☞Fasten your seat belt –seeSeat belt (lap belt) on page 3-23
☞Disabling the drive interlock
–seeDisabling (releasing) the drive interlock on page 3-27
☞Set the manual throttle (option) to idling speed
–seeManual throttle (option) on page 3-46
☞Set the low-speed control (option) to the zero position
–seeLow-speed control (option) on page 3-47
☞Set the control lever for the loader unit to neutral
–seeSelecting a travel direction and starting machine travel on page 3-51
Notices on starting the engine
In order to avoid damage to the engine and the exhaust turbocharger due to
insufficient lube oil supply:
☞Do not run the cold engine at full throttle when starting
☞Let the engine warm up at low idling speed (1/4 throttle) for about 30 seconds
☞When the engine runs smoothly, check whether indicator lights 38 and 40
have gone out
☞Have a malfunctioning indicating instrument immediately replaced
In order to avoid damage to the starter, do not stop the engine and immediately
start it again.
☞After stopping the engine, wait 10 seconds before starting it again.
When ignition is switched on, all indicator lights on the indicating instrument
illuminate briefly. – indicator light check!
To Next Page
Loading...
