Kramer 5035

5-42 BA 348-01 * 2.0 * 34801b520.fm
5 Maintenance
Maintenance
5.22 Maintenance plan
Important information on the maintenance plan
For servicing and maintenance on the attachment, please refer to the operation and
maintenance manual of the attachment manufacturer as well.
Have maintenance, the Delivery Inspection, the 1st Inspection at 100 operating hours
and the 2nd Inspection every 500 and 1500 operating hours (once a year) performed
by an authorized service centre, otherwise warranty claims will not be acknowledged.
Maintenance plan overview
Work description
1
Service
centre
User/operator
Service centre
Delivery
inspection
Maintenance
(once a day)
Every 50 o/h
“A”
1st Inspection
at 100 o/h
2
“B” every
500 o/h
2
“C” every
1500 o/h
once a year
Oil and filter changes ( ) (check the oil levels after a test run):
• Change the engine oil
●●●
• Replace the engine oil filter
●●●
• Replace fuel filter, fuel prefilter
●●●
• Replacing the fuel/water separator
●●
• Replace the air filter insert
3, 4
, replace the safety cartridge
every 3rd time the air filter insert is replaced
●●
• Replace the hydraulic oil
5
●
• Replace the hydraulic oil filter insert
●●
• Replace the hydraulic oil reservoir breather filter
4
●
• Replace the fine-dust filter
6
of the heating and ventilation
system
●●
Inspection work ( ) :
• Check engine oil level
●
●
• Check hydraulic oil level
●
● ●●
• Check the engine coolant level
7
(also check the antifreeze at temperatures below 4 °C!)
●
● ●●●
• Check radiator for engine and hydraulic oil for contamination.
Clean if necessary
8
● ●●●●
• When using biodegradable oil:
drain the condensation water in the hydraulic oil reservoir
5
●●
• Clean dust valve on air filter housing
3
● ● ●●●
• Check the pedals. Clean them and apply grease or oil if
necessary
● ●●●
• Check the locks/door arrester. Clean them and apply grease or
oil if necessary
● ●●●
• V-belt: check condition and pre-tension
●
●
• V-belt: check condition and pre-tension. Retighten or replace if
necessary
●
●●●