Kramer VS-44DT

Figure 1: VS-44DT 4x4 HDMI/HDBT Matrix Switcher Front Panel
#
Feature
Function
1
IR LED
Lights yellow when receiving an IR signal
2
IR Sensor
IR receiver for remote control
3
POWER LED
Lights green when the device is powered on
4
IN Buttons
Press to select an input after selecting an output (from 1 to 4), see Section 6.1
5
OUT Buttons
Press to select an output followed by an input or OFF (from 1 to 4)
6
ALL Button
Press followed by an input to switch this input to all outputs, or press followed by the Off button to disconnect all switches,
(see Section 6.4)
7
STO Button
Press to store a preset configuration followed by the preset number in which to save it, (see Section 6.2)
8
EDID Button
Press to copy the EDID from an output to an input, (see Section 6.3)
9
LOCK Button
Press and hold to lock the front panel buttons, (see Section 6.6). Press and hold again to unlock
10
MENU Button
Press to enter the configuration menu or to move up one level when inside the menu, (see Section 7.1)
11
Menu Navigation
Pad
Use the Enter, up (▲), down (▼), left (◄), and right (►) buttons to navigate the menu or to modify parameters or values
within the menu, (see Section 7.1)
12
LCD Readout
(20 char x 2 lines)
Displays either the input/output matrix currently selected or the menu during configuration
13
OFF Button
Press after an output button to disconnect the currently selected outputs. Press after the All button to disconnect all
currently switched outputs (see Section 6.4)
14
RCL Button
Press, followed by a preset number to recall the preset configuration (see Section 6.2)
6
VS-44DT – Overview