Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 2
2.3 Shielded Twisted Pair/Unshielded Twisted Pair 3
2.4 Recycling Kramer Products 3
3 Overview 4
3.1 About HDBaseT™ Technology 5
3.2 Defining the VS-44DT 4x4 HDMI/HDBT Matrix Switcher 5
4 Installing in a Rack 9
5 Connecting the VS-44DT 10
5.1 Connecting the VS-44DT to a Serial Controller 11
5.2 Connecting the VS-44DT to a Serial Data Source/Acceptor 11
5.3 Connecting to the VS-44DT via Ethernet 12
5.4 Wiring the RJ-45 Connectors 16
6 Operating the VS-44DT 17
6.1 Switching Inputs to Outputs 17
6.2 Storing and Recalling Preset Configurations 18
6.3 Acquiring an EDID 19
6.4 Disconnecting One or All Outputs 19
6.5 Resetting the Device to Factory Default Configuration 20
6.6 Locking and Unlocking the Front Panel 21
7 Configuring the VS-44DT 22
7.1 Using the Menu 22
7.2 Selecting DHCP 24
7.3 Configuring the IP Network Address 24
7.4 Resetting the VS-44DT to Factory Default Configuration 25
8 Operating the VS-44DT Remotely Using the Web Pages 26
8.1 Switching Page 27
8.2 Device Settings Page 31
8.3 Authentication Page 32
8.4 EDID Page 34
8.5 RS-232 Routing Page 36
8.6 Audio Settings Page 37
8.7 Switching Timeout Page 38
8.8 About Page 39
9 Updating the Firmware 40
10 Technical Specifications 42
10.1 Default IP Parameters 43
11 Protocol 3000 44
11.1 Understanding Protocol 3000 45
11.2 Kramer Protocol 3000 Syntax 46
11.3 Protocol 3000 Commands 47
11.4 Kramer Protocol 3000 Commands 48
To Next Page
Loading...
