VS-44DT - Configuring the VS-44DT
7.1.6 FW Version Display
Displays the firmware version.
7.1.7 Reset to Default
Resets the device to default factory parameters (NO or YES)
7.1.8 Update Firmware Sub-menu
Updates the firmware (NO or YES)
7.2 Selecting DHCP
To select the DHCP:
1. Press the Menu button to display the menu.
The menu is displayed.
2. Using the up (▲) or down (▼) button, move through the menu options until
the Network Settings option is displayed.
3. Press Enter.
The DHCP ON and OFF options are displayed.
4. Using the left (◄) or right (►) button, select either ON or OFF.
5. Press Enter.
The change is saved.
7.3 Configuring the IP Network Address
To configure the IP network address:
1. Press the Menu button to display the menu.
The menu is displayed.
2. Using the up (▲) or down (▼) button, move through the menu options until
the Network Settings option is displayed.
To Next Page
Loading...
