Kramer VS-44DT - VS-44 DT Network and RS-232 Settings; Setting RS-232 Routing; Setting Auto Switching; Setting Network Parameters

VS-44DT - Configuring the VS-44DT
23
23
7.1.2 Setting RS-232 Routing
The RS-232 Status sub-menu turns the RS-232 DATA serial communication routing
on and off. The current state is displayed when entering the RS-232 ROUTING
menu, for example: ON To port-04.
Parameter
Description
To Port:
Turns the RS-232 routing to each port (1 to 4) ON or OFF
7.1.3 Setting Auto Switching
The AUTO SETTINGS sub-menu lets you enable or disable auto switching.
Parameter
Description
AUTO SWITCH: OUT (1 to 4)
Sets auto switching ON or OFF
7.1.4 Setting the Network Parameters
The Network Status sub-menu controls DHCP selection and IP network
parameters.
Parameter
Description
OFF, ON
Turns DHCP ON and OFF. When off, set the network
parameters (see Section 7.2)
IP Settings
Sets the IP network address
Netmask Settings
Sets the IP netmask
Gateway Settings
Sets the IP gateway
Note: When turning DHCP on, the device performs an automatic reset.
7.1.5 Ethernet Status Sub-menu
The parameters in the Ethernet Status sub-menu display the TCP/IP
communication parameters.
Parameter
Description
Default
IP Status:
Displays the TCP/IP address of the device
192.168.1.39
Netmask Status:
Displays the TCP/IP netmask of the device
255.255.0.0
Gateway Status:
Displays the TCP/IP gateway
192.168.0.1
TCP port
Set the TCP port number (0 to 65535)
5000
UDP Port
Set the UDP port number (0 to 65535)
50000
MAC Address:
Displays the MAC address of the device
-