VS-44DT - Connecting the VS-44DT
4. Connect the OUT 2 HDMI connector to an HDMI acceptor, (for example, a
display).
5. Connect the OUT 1 HDBT RJ-45 connector to a compatible HDBT receiver,
(for example, the TP-580Rxr), and connect the HDMI output of the
TP-580Rxr to a display.
6. Connect the OUT 3 HDBT RJ-45 connector to a compatible HDBT receiver,
(for example, the TP-580Rxr), and connect the HDMI output of the
TP-580Rxr to a display.
7. Connect the AUDIO OUT 3.5mm mini jack to an audio acceptor, (for
example, active speakers).
8. Connect a controller via either RS-232 or a LAN to the Ethernet RJ-45
connector.
5.1 Connecting the VS-44DT to a Serial Controller
You can connect the VS-44DT via an RS-232 connection to a serial controller, for
example, a PC.
To connect the VS-44DT via RS-232 to a serial controller:
Connect the RS-232 CONTROL 3-pin terminal block on the rear of the
VS-44DT to the 9-pin D-sub connector on PC, (pin TX to pin 2, pin RX to pin
3, pin G to pin 5)
5.2 Connecting the VS-44DT to a Serial Data
Source/Acceptor
You can connect the VS-44DT via an RS-232 connection to a serial data source or
acceptor, for example, a PC or device to be controlled.
To connect the VS-44DT via RS-232 to a serial data controller or acceptor:
Connect the RS-232 DATA 3-pin terminal block on the rear of the
VS-44DT to the 9-pin D-sub connector on PC, (pin TX to pin 2, pin RX to pin
2, pin G to pin 5)
To Next Page
Loading...
