Kramer VS-44DT

VS-44DT - Operating the VS-44DT
19
19
6.3 Acquiring an EDID
You can acquire the EDID from an output and assign it to either one or all inputs.
To acquire the EDID from an output and store it on one input, (for example,
Output 3 to Input 1):
1. Press EDID.
The button lights red.
2. Press Out 3.
3. Press In 1.
4. Press EDID.
The button no longer lights and the EDID from Output 3 is stored in Input 1.
6.4 Disconnecting One or All Outputs
The Off button is used to disconnect one or all currently switched outputs.
To disconnect one currently switched output, (for example, Output 2):
1. Press Out 2.
2. Press OFF.
To disconnect all currently switched outputs:
1. Press ALL.
2. Press OFF.