Kramer VS-44DT - Kramer Protocol 3000 Syntax

VS-44DT - Protocol 3000
45
45
 K-Config (Kramer configuration software):
All the examples provided in this section are based on using the
K-Config software.
You can enter commands directly using terminal communication software (e.g.,
Hercules) by connecting a PC to the serial or Ethernet port on the VS-44DT. To
enter CR press the Enter key (LF is also sent but is ignored by the command
parser).
Commands sent from various non-Kramer controllers (e.g., Crestron) may require
special coding for some characters (such as, /X##). For more information, refer to
your controller’s documentation.
For more information about:
 Using Protocol 3000 commands, see Section 11.1
 General syntax used for Protocol 3000 commands, see Section 11.2
 Protocol 3000 commands available for the VS-44DT, see Section 11.3
11.1 Understanding Protocol 3000
Protocol 3000 commands are structured according to the following:
 Command – A sequence of ASCII letters (A-Z, a-z and -). A command
and its parameters must be separated by at least one space.
 Parameters – A sequence of alphanumeric ASCII characters (0-9, A-Z,
a-z and some special characters for specific commands). Parameters are
separated by commas.
 Message string – Every command entered as part of a message string
begins with a message starting character and ends with a message closing
character.