Kramer VS-44DT

VS-44DT - Operating the VS-44DT
17
17
6 Operating the VS-44DT
When the VS-44DT is powered on, the following is displayed briefly on the LCD
display:
KRAMER ELECTRONICS
4X4 HDMI/HDBT Matrix
Following the self-test the current switching configuration is displayed, an example
of which is shown below. The top row indicates the output port and the bottom row
indicates which input port is switched to the output port displayed directly above it.
An input port showing 0 (zero) indicates that the output port has no input switched
to it.
O:
1
2
3
4
I:
3
0
1
2
When operating via the front panel buttons, if there is no button
activity for approximately 30 seconds, the procedure is aborted and
the display reverts back to the Input / Output display.
After approximately 8 minutes of no activity, the LCD turns off.
Push any button to turn the LCD back on.
6.1 Switching Inputs to Outputs
You can switch:
 Individual inputs to individual outputs
 One input to all outputs
To switch an output to an input, (for example, Input 4 to Output 3):
1. Press Out 3.
The Output button lights red.
2. Press In 4.
The Input button lights red and the switch is executed.