VS-88H2 – Operating VS-88H2 via Front Panel Buttons
Storing and Recalling a Setup
The number of setups that the Matrix Switcher is the sum of the inputs and outputs of the
device. For example, VS-66H2, VS-84H2 and VS-48H2can store/recall up to 12 setups, while
VS-88H2 stores/recalls up to 16 setups.
VS-66H2, VS-84H2 and VS-48H2 can store/recall up to 16 setups via the protocol commands
(see Protocol 3000 Commands on page 64).
Each setup includes the video and audio current switching state, the EDID, the ARC/audio
mode, and the switch mode and speed.
In Store-Recall mode, OUT 1 corresponds to setup 1, IN 1 corresponds to setup 9, and so on.
Figure 16: VS-88H2 8x8 H2 Matrix Switcher Front Panel
To store a setup:
1. Press STO .
The STO button illuminates.
2. Press an IN or an OUT button (from 1 to 8).
The selected button flashes.
3. Press STO.
The current device state is stored to the selected setup and the STO button no longer
illuminates.
To recall a setup:
1. Press RCL .
The RCL button illuminates.
2. Press an IN or OUT button.
The selected button flashes.
If a setup is stored in the selected setup button, the corresponding 7-segment display
LED flashes. If nothing is stored the 7-segment LED is on.
3. Press RCL.
The recalled setup is applied and the RCL button no longer illuminates.
If you do not press RCL within 15 seconds, the recall setup process times out.
To Next Page
Loading...
