Kramer VS-88H2

Kramer Electronics Ltd.
VS-88H2 – Operating VS-88H2 via Front Panel Buttons
23
Setting Switching Mode
Set the following switching modes separately for each output:
• Manual mode (IN 1): inputs are switched to outputs via the front panel buttons.
• Priority mode (IN 2): the VS-88H2 switches the source with the highest priority to the
output.
• Last connected mode (IN 3): the last detected active source is switched to the output.
To select the switching mode:
1. Press RCL and MUTE/PATTERN simultaneously.
Both buttons illuminate.
2. Press an output button (or press ALL).
The corresponding 7-segment display LEDs flash and LOCK button flashes.
3. Press IN 1, IN 2 or IN 3.
4. Press LOCK.
The switching mode is set for the selected output.
Setting Switching Speed
Set the following switching speed modes separately for each output:
• Extra-Fast switch speed (IN 1).
• Fast switch speed (IN 2).
• Normal switch speed (IN 3).
To select the switching speed:
1. Press STO and MUTE/PATTERN simultaneously.
Both buttons illuminate and the 7-segment display LEDs show the current switch speed
for each port.
2. Press an output button (or press ALL).
The corresponding 7-segment display LEDs flash and LOCK button flashes.
3. Press IN 1, IN 2 or IN 3 and press LOCK.
The selected switching speed is set.