Managing Timeout Settings
Use the Timeout Settings web page to set the time delay to shut down if no input signal is
detected for each output and also to set the auto switching time.
The Timeout Settings web page enables performing the following functions:
• Setting Timeout on page 46.
• Setting Support Audio Only on page 47.
• Setting Video Signal Lost Timer on page 47.
Setting Timeout
To set the timeout:
1. In the Navigation pane, click Timeout Settings.
The Timeout Settings page appears:
Figure 39: Timeout Settings Page
2. Set the specific output delay time.
If you do not want a specific output to shut down when an input signal is not detected, check the Never
box next to the desired output.
To Next Page
Loading...
