Setting Support Audio Only
Set audio support ON if you want shutdown to occur only if an audio signal is lost.
Support audio only can be used if the video and audio signals routed to an output, come
from separate sources.
To set support audio only:
1. In the Navigation pane, click Timeout Settings.
The Timeout Settings page appears (Figure 39).
▪ Set Support audio only to ON – The audio signal routed to the output remains active
when the video source (coming from a different input) is deactivated.
▪ Set Support audio only to OFF – The audio signal routed to the output is deactivated
together with the deactivation of the video source (coming from a different input).
Setting Video Signal Lost Timer
To set the video signal lost timer (when in auto-switching mode):
1. In the Navigation pane, click Timeout Settings.
The Timeout Settings page appears (Figure 39).
2. Set the video lost timer.
If the video is lost when in the auto switching mode (Priority or Last connected) you can set
the time the device waits before it switches to the next source.
To Next Page
Loading...
