Safety 2
Basic safety instructions 2.3
ActiveMow R 200
Original Operating Instructions 150000521_04_en 17
Danger zone because objects may shoot out
Crops and foreign bodies may shoot out and injure or kill people.
Before starting the machine, instruct all people to leave the danger zone of the machine.
If people are in the danger zone of the machine, switch off drives and diesel engine
immediately.
Danger zone when drive is switched on
When drive is switched on, there is danger to life caused by moving machine parts. People
must not stay in the danger zone of the machine.
Before starting the machine, instruct all persons to leave the danger zone of the machine.
In case of dangerous situations, immediately switch off drives and instruct persons to leave
the danger zone.
Danger zone due to trailing machine parts
If machine parts are trailing, people may be seriously injured or killed.
After the drives have been switched off, the following machine parts will trail:
• Universal shafts
• Cutting discs
• Conditioner
• Conveying devices
Shut down and safeguard the machine, refer to page24.
Do not approach the machine until all machines parts have come to a complete stop.
2.3.11 Ensuring functionality of safety devices
If safety devices are missing or damaged, moving machine parts could seriously hurt or kill
persons.
Replace damaged safety devices.
Mount dismounted safety devices and machine parts again before start-up and move them
to protective position.
When there are doubts whether all safety devices are functional and have been correctly
installed, instruct a specialist workshop to check this.
2.3.12 Personal protective equipment
The wearing of personal protective equipment is an important safety measure. Missing or
unsuitable personal protective equipment increases health risks and injuries.
To Next Page
Loading...
Need help?
General
