Maintenance - Gearbox 13
Main gearbox 13.2
ActiveMow R 200
Original Operating Instructions 150000521_04_en 65
Change oil
ü A suitable container is available for escaping oil.
Unscrew the locking screw from the inspection hole(1) and the locking screw from the filling
hole(3).
Unscrew the oil drain plug(2) and drain the oil.
Screw in the oil drain plug(2), tightening torque refer to page60.
Refill with fresh oil up to the inspection hole (1) via the filling hole (3).
Screw the locking screw into the inspection hole(1) and the locking screw into the filling
hole(3), tightening torque refer to page60.
13.2 Main gearbox
KMG000-073
Observe the safety routine “Safely performing oil level check, oil change and filter element
change”, refer to page25.
INFORMATION
The oil level must be checked and the oil must be changed in working position and with
machine in horizontal position.
Check oil level
Unscrew the locking screw of the inspection hole (1).
ð If the oil reaches up to the inspection hole(1):
Screw on the locking screw of the inspection hole (1), tightening torque refer to
page60.
ð If the oil does not reach up to the inspection hole(1):
Remove the locking screw from the filling hole (3).
Refill with fresh oil up to the inspection hole (1) via the filling hole (3).
Screw on the locking screw of the inspection hole(1) and the locking screw of the filling
hole(3), tightening torque refer to page60.
To Next Page
Loading...
Need help?
General
