Krone ActiveMow R 200 - Maintenance - Every 10 Hours, but at Least Once a Day; Maintenance - Every 50 Hours; Maintenance - Every 200 Hours; Maintenance - Every 6 Years

Maintenance - General Information 11
Maintenance table 11.1
ActiveMow R 200
Original Operating Instructions 150000521_04_en 57
Components
Check/replace retaining bolt (blade quick
fastener)
refer to page72
Check/replace blade carrier (blade quick
fastener)
refer to page73
Check/replace linings on cutterbar refer to page76
Vent friction clutch refer to page61
Check guard cloths refer to page62
Tighten screws/nuts refer to page58
11.1.3 Maintenance - Every 10 hours, but at least once a day
Checking oil level
Input gearbox refer to page64
Main gearbox refer to page65
Cutterbar refer to page77
Components
Changing/replacing blades refer to page69
Check/replace cutting discs/mower drums refer to page75
Check/replace retaining bolt (blade screw con-
nection)
refer to page72
Check/replace retaining bolt (blade quick
fastener)
refer to page72
Check guard cloths refer to page62
11.1.4 Maintenance - Every 50 hours
Components
Tighten screws/nuts on the machine refer to page58
11.1.5 Maintenance - Every 200 hours
Changing oil
Input gearbox refer to page64
Main gearbox refer to page65
11.1.6 Maintenance - Every 6 years
Components
Have the hydraulic hoses replaced by your
KRONE service partner