Krone EasyCut B 870 CV Collect - Checking the Oil Level; Oil Change

Maintenance - hydraulic system
101
Pos: 150 /Überschr iften/Überschrif ten 3/K-O/Ölkontrolle @ 0\ mod_1197021908190_78. docx @ 16120 @ 3 @ 1
15.1.2 Checking the oil level
Pos: 151 /BA/Sonderau sstatung/EasyCut / AM Mähwerke/Querförder er/Hydraulik Ölstand skontrolle Bild EC B 870 CV Co llect @ 231\mod_1393 487177097_78.doc x @ 1850328 @ @ 1
Fig. 60
Pos: 152 /BA/Sonderau sstatung/EasyCut / AM Mähwerke/Querförder er/Hydraulik-Öls tandskontrolle @ 10\ mod_1222335584255_78. docx @ 140585 @ @ 1
Check the hydraulic oil level after every 10 operating hours of the cross conveyor.
To do this:
• Lower the machine and switch off the engine.
• Unscrew and remove the ventilation filter (2) (with measuring rod).
• • Use a lint-free cloth to clean the ventilation filter (2) and insert it again completely.
• Pull out the ventilation filter (2) again.
• The oil level must lie between the min. and max. mark.
• Top off with hydraulic oil if necessary.
• Screw in and tighten the ventilation filter (2).
Pos: 153 /Überschr iften/Überschrif ten 3/K-O/Ölwechsel @ 0\ mod_1197021941955_78. docx @ 16139 @ 3 @ 1
15.1.3 Oil change
Pos: 154 /BA/Sonderau sstatung/EasyCut / AM Mähwerke/Querförder er/Hydraulik-Öl wechsel @ 10\mod_1222335966 973_78.docx @ 140673 @ @ 1
Change the hydraulic oil every 500 hours (but at least once a year).
• Unscrew and remove the ventilation filter (2) (with measuring rod).
• Screw out the oil drain plug (3).
• Collect the used oil in a suitable drip pan.
• Screw in the oil drain plug (3).
• Top up oil (2) (the oil level must lie between the min. and max. mark).
• Screw in and tighten the ventilation filter (2).
Pos: 155 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1