EasyManua.ls Logo

Krone EasyCut B 870 CV Collect - Settings; Adjusting the Cutting Height

Krone EasyCut B 870 CV Collect
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Settings
60
Pos: 119.1 /Übersc hriften/Überschri ften 1/A-E/Einstellung en @ 0\mod_1199868783 862_78.docx @ 36141 @ 2 @ 1
11 Settings
Pos: 119.2 /BA/Sic herheit/7. Gefahrenhin weise alt/Mähwerke/ Warnung - Einstellarbei ten angebaute Masc hinen @ 254\mod_13974878 75458_78.docx @ 1953794 @ @ 1
DANGER! - Unexpected movement of the machine
Effect: Danger to life or serious injuries.
Setting tasks must only be performed when the drive is switched off and the engine is at a
standstill!
Switch off engine.
Remove the ignition key and carry it with you.
Secure the tractor against rolling away.
Pos: 119.3 /BA/Sic herheit/7. Gefahrenhin weise alt/Gefahr - Unfallgefahr durch unbeab sichtiges Senken des Querförderers @ 101\mod _1330612168305_78.doc x @ 898030 @ @ 1
Danger!
Accident hazard through unintentional lowering of the cross conveyor.
Effect: Danger to life or serious injuries.
Work may only be done under the raised cross conveyor when the cross conveyor
stopcock is closed.
Pos: 119.4 /Übersc hriften/Überschri ften 2/A-E/Einstellen der Schnitthöhe @ 0\mod_1 196660879619_78.doc x @ 9191 @ 1 @ 1
11.1 Adjusting the cutting height
Pos: 119.5 /BA/Einste llungen/Mähwerke/Sc hnitthöhe/Schni tthöhe Bild EC B 1000 @ 100\mod _1330082415443_78.doc x @ 889947 @ @ 1
Fig. 26
Pos: 119.6 /BA/Sic herheit/7. Gefahrenhin weise alt/Sicher heitshinweise am Anfang des Ka pitels beachten @ 101\ mod_1330611811687_7 8.docx @ 897943 @ @ 1
Observe the safety instructions at the beginning of the section.
Pos: 119.7 /BA/Einste llungen/Mähwerke/Sc hnitthöhe/Schni tthöhe größer_geringer EC280/320 @ 9\mod_122 0960304209_78.doc x @ 130271 @ @ 1
The cutting height is adjusted via the top link (1).
To do this:
Swivel the parking support(s) down
Lower the machine into working position and set it down on the parking support(s).
Rotate the top suspension arm (1).
Fold in the parking support(s).
Top suspension arm longer = bigger cutting height
Top suspension arm shorter = smaller cutting height
Pos: 119.8 /Layout Modu le /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1

Table of Contents

Related product manuals