KTM 2016 RC 390 User Manual

18 SERVICE WORK ON THE ENGINE 154
401955-12
–
Remove filler plug

and the O-ring from the clutch cover and fill up with engine oil.
Engine oil 1.7 l (1.8 qt.) Engine oil (SAE 15W/50) ( p. 185)
– Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in
unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effective
exhaust extraction system.
– Start the engine and check that it is oil-tight.
Finishing work
– Fit the front spoiler. ( p. 95)
– Install the left side cover. ( p. 98)
– Install the right side cover. ( p. 101)
– Check the engine oil level. ( p. 151)
18.3 Adding engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.

KTM 2016 RC 390 Specifications

General

Displacement	373.2 cc
Bore x Stroke	89 mm x 60 mm
Compression Ratio	12.6:1
Power	32 kW (44 hp) @ 9, 500 rpm
Torque	35 Nm @ 7, 250 rpm
Transmission	6-speed
Rear Suspension	WP monoshock
Rear Brake	230 mm disc, single-piston caliper
Front Tire	110/70 ZR17
Rear Tire	150/60 ZR17
Seat Height	820 mm
Fuel Tank Capacity	10 liters
Dry Weight	147 kg
Ground Clearance	178.5 mm
Engine Type	Single-cylinder, 4-stroke
Fuel System	Electronic Fuel Injection
Front Suspension	WP USD 43 mm
ABS	Bosch 9MB Two-Channel ABS
Frame	Steel trellis frame
Front Brake	300 mm disc, 4-piston radial caliper