SAFETY ADVICE 2
11
rises above the permissible operating temperature, the power of the vehicle is reduced markedly. This protects
the system against damage from overheating. When power reduction is imminent, the active driving mode indica-
tor flashes. When power reduction is active, all three driving mode indicators light up. When all components have
returned to their normal operating temperature, full system power is restored after restarting.
Only operate the vehicle when it is in perfect technical condition, in accordance with its intended use, and in a
safe and environmentally compatible manner.
Have malfunctions that impair safety promptly eliminated by an authorized KTM workshop.
Adhere to the information and warning labels on the vehicle.
2.8 Fall or accident
Warning
Risk of injury The outside of a damaged vehicle may be conducting live current.
– Contact the KTM customer service immediately if major damage has occurred to the rechargeable
lithium-ion battery (KTM PowerPack) or to the engine.
If the vehicle is lying on its side, it switches from ready mode to standby mode after seven seconds. To switch the
vehicle back into ready mode, place it in an upright position and press the start button.
After a fall or accident, check the vehicle as usual when preparing for use.
2.9 Protective clothing
Warning
Risk of injury Missing or poor protective clothing presents an increased safety risk.
– Wear appropriate protective clothing such as helmet, boots, gloves as well as trousers and a jacket
with protectors on all rides.
– Always wear protective clothing that is in good condition and meets the legal regulations.
2.10 Work on the vehicle, motor, and lithium-ion battery (KTM PowerPack)
Warning
Risk of injury There is a risk of electric shock when working on high-voltage components.
Work on high-voltage components requires special training, qualifications and tools.
– Have all work that is not described and explained performed by trained KTM mechanics only.
– Do not open the electric motor or the lithium-ion battery (KTM PowerPack).
Warning
Risk of injury The vehicle runs very quietly, even when it is ready to operate.
The vehicle starts moving in an uncontrolled manner if the throttle grip is accidentally touched while
work is being performed on the vehicle.
The high-voltage components of the vehicle are only deactivated if the vehicle is switched off at the
main switch.
– Ensure that the vehicle is switched off at the main switch and remains switched off while any work is
being performed on the vehicle.
– Remove the power pack from the vehicle before you start any work on the vehicle.
– Protect the vehicle against access from unauthorized persons while you are performing work on the
vehicle.
To Next Page
Loading...
