KTM Freeride E-XC 2019 - Removing the Fork Legs

13 SERVICE WORK ON THE CHASSIS
60
– Clean and oil the dust boots and inner fork tubes of both fork
legs.
Universal oil spray ( p. 139)
– Press the dust boots back into their normal position.
– Remove excess oil.
Finishing work
– Install the fork protector. ( p. 59)
– Remove the motorcycle from the lift stand. ( p. 57)
– Install the KTM PowerPack. ( p. 108)
– Lock the seat. ( p. 69)
13.7 Removing the fork legs
Preparatory work
– Deactivate the vehicle. ( p. 43)
– Fold the seat up. ( p. 69)
– Remove the KTM PowerPack. ( p. 107)
– Mount the protection cap. ( p. 71)
– Raise the motorcycle with a lift stand. ( p. 57)
– Remove the front wheel. ( p. 91)
– Remove the headlight mask with the headlight. ( p. 101)
F01668-10
Main work
–
Remove screws
1
and take off the clamp.
– Remove the cable tie(s) and detach plug-in connector.
–
Remove screws
2
with the spacers and take off the brake
caliper.
– Allow the brake caliper and brake line to hang loosely to the
side.
A00182-10
–
Loosen screws
3
. Take out the left fork leg.
–
Loosen screws
4
. Take out the right fork leg.