24 TECHNICAL DATA
132
24.1 Engine
Design Permanent magnet synchronous motor with a disc
motor design
Primary transmission 1:2.4
Cooling Water cooling, permanent circulation of coolant by
electric water pump
24.2 Engine tightening torques
Coolant drain plug M6 10 Nm (7.4 lbf ft)
Oil seal plug M10 8 Nm (5.9 lbf ft)
Oil drain plug with magnet M12x1.5x12 20 Nm (14.8 lbf ft)
24.3 Capacities
24.3.1 Gear oil
Gear oil 0.2 l (0.2 qt.) Gear oil (SAE 80W/90) ( p. 137)
24.3.2 Coolant
Coolant 0.7 l (0.7 qt.) Coolant ( p. 137)
24.4 Chassis
Frame Perimeter, steel-aluminum composite frame
Fork WP SuspensionXplor 43
Suspension travel
front 250 mm (9.84 in)
rear 260 mm (10.24 in)
Fork offset 20 mm (0.79 in)
Shock absorber WP SuspensionXplor PDS
Brake system
front Disc brake with radially mounted 4-piston brake
caliper
rear Disc brake with radially mounted 2-piston brake
caliper
Brake discs - diameter
front 260 mm (10.24 in)
rear 230 mm (9.06 in)
Brake discs - wear limit
front 3.7 mm (0.146 in)
rear 3.5 mm (0.138 in)
Offroad tire pressure
front 0.9 bar (13 psi)
rear 0.7 bar (10 psi)
Street tire pressure
front 1.5 bar (22 psi)
To Next Page
Loading...
