TROUBLESHOOTING 23
129
Faults Possible cause Action
Blink code 44 on the vehicle Fault in the 12 V supply – Charge the 12 V battery. ( p. 99)
– Install a new 12 V battery.
Blink code 45 on the vehicle Fault in the electric motor – Switch the main switch off and on.
Blink code 46 on the vehicle Fault in the onboard network
wiring harness or in a switch
– Switch the main switch off and on.
– Check the onboard network wiring har-
ness and plug-in connections for exter-
nal damage.
Blink code 51 on the vehicle Electric motor control unit error – Switch the main switch off and on.
Blink code 52 on the vehicle Fault in the moisture monitor – Switch the main switch off and on.
Blink code 53 on the vehicle Fault in the KTM PowerPack
relay
– Switch the main switch off and on.
Blink code 54 on the vehicle Fault in the insulation monitor – Clean and dry the discharge plug and
discharge socket without compressed
air.
Speedometer values deleted
(time, stop watch, lap times)
The combination instrument
battery is empty
– Change the combination instrument
battery. ( p. 106)
The high beam, low beam,
position light, tail light, and
license plate lamp are not
working
Fuse 3 blown – Change the fuses of individual power
consumers. ( p. 100)
The combination instrument,
horn, brake light, and turn sig-
nal are not working
Fuse 4 blown – Change the fuses of individual power
consumers. ( p. 100)
To Next Page
Loading...
