KUHN FC313RF - Flow Limiter

112 pages

Save Page as PDF

To Next Page

To Previous Page

9. - Optional equipment

FC313RF

KN021BGB K

Mower conditioner

9.4 Flow limiter

Kit no. 1076550

Main Page

Dear Owner3
Table of Contents4
Contents4
Identification of the Machine7
Front View7
Rear View7
Model Identification Plate8
Optional Equipment9
Safety10
Description of Symbols Used in this Document10
Safety Instructions11
Introduction11
Read and Follow the Safety Instructions11
Precautions to be Taken before Carrying out any Operations on the Machine12
Precautions to Take before Using the Machine12
Precautions When Driving13
Precautions When Driving on Public Roads14
Maximum Speed18
Precautions When Coupling18
Hydraulic Circuit19
PTO Shaft20
Precautions During Manoeuvres22
Remote Controlled Components22
Safety Decals22
Waste Disposal22
Precautions for Maintenance and Repair Work23
Projection of Stones and Foreign Objects24
Precautions for Machine Use25
Location and Description of Safety Decals on the Machine26
Location of Safety Decals26
Description of Safety Decals27
Road Safety Equipment and Recommendations30
Instructions Specific to France31
Machine Specifications32
Description and Glossary32
Technical Specifications34
Sound Levels34
Putting into Service35
Description of Control Elements35
Coupling and Uncoupling35
Description of Coupling Elements35
Preparing the Tractor36
Preparing the Machine39
Coupling the Machine44
Hydraulic Connection45
Electrical Connection46
Primary PTO Shaft47
Intermediate PTO Shaft49
Adjusting the Machine51
Fitting the Rear Protection Cover52
Uncoupling the Machine53
Instructions for Transport54
Putting the Machine into Transport Position54
Conformity with the Road Regulations55
Instructions for Work56
Putting the Machine into Work Position56
Adjustments in Working Position57
Cutting Height57
Ground Pressure58
Conditioning Intensity60
Machine Use61
Drive Speed61
Machine Safety62
Optional Equipment63
Side Deflector Kit63
Quick Release "A" Frame Coupler64
Mowing Unit Stops64
Flow Limiter65
Maintenance and Storage66
Frequency Chart66
Cleaning the Machine67
Lubrication68
PTO Shaft69
Grease71
Oil73
Oil Change74
Maintenance77
Hydro-Pneumatic Accumulators77
Basic Adjustments79
Checking the Roller Parallelism and Gap80
Drive Chain Tension81
Chain Replacement and Roller Synchronization82
Belt Tension85
Replacing the Belts86
Checking Cutterbar Oil Level87
Inspection of Knives and Securing Elements88
Knife Replacement90
Disc Replacement91
Outer and Inner Cones93
Storage94
At the End of each Season94
At the Start of each Season95
Troubleshooting Guide96
Appendix98
Calculating the Load on an Axle98
Limited Warranty108

KUHN FC313RF - Flow Limiter

Table of Contents

Related product manuals