KUHN FC3160 TCD

To Next Page

To Previous Page

FC3160-3560-4060 TCD

5. - Machine specifications

KN284EGB_A

Mower conditioner

1 : Intermediate PTO shaft 1 2 : Cutterbar

3 : Pitch angle adjustment rod 4 : Conditioning lever adjustment

Main Page

Dear Owner3
Table of Contents4
Contents4
Identification of the Machine7
Front View7
Rear View7
Location of the Plates8
Description8
Optional Equipment12
Safety13
Description of Symbols Used in this Document13
Safety Instructions14
Introduction14
Read and Follow the Safety Instructions14
Safety Decals15
Precautions to be Taken before Carrying out any Operations on the Machine15
Precautions When Coupling15
PTO Shaft16
Hydraulic Circuit18
Remote Controlled Components18
Precautions When Driving19
Precautions When Driving on Public Roads19
Maximum Speed20
Tyres21
Precautions to Take before Using the Machine21
Precautions During Manoeuvres21
Precautions for Machine Use22
Projection of Stones and Foreign Objects23
Waste Disposal23
Precautions for Maintenance and Repair Work24
Burn Hazard24
Precautions to Take before Using the Parking Stands25
Location and Description of Safety Decals on the Machine26
Location of Safety Decals26
Description of Safety Decals27
Road Safety Equipment and Recommendations28
Tyre Pressure29
Instructions Specific to France29
Specific Recommendations for the European Union30
Likely Critical Failures30
Incorrect Use of the Machine by the User31
Limit State Criteria31
Machine Handling31
Machine Specifications33
Description and Glossary33
Designated Use of the Machine36
Technical Specifications36
Designated Parameters36
Required Equipment37
Check Chains37
Sound Levels37
Putting into Service38
Description of Control Elements38
Coupling and Uncoupling39
Description of Coupling Elements39
Prevention against Unauthorised Use39
Preparing the Tractor39
Hydraulic Connections42
Electrical Connections43
Fit the Check Chains43
Primary PTO Shaft43
Intermediate PTO Shaft45
Adjusting the Machine48
Instructions for Transport50
Transport Position50
Putting the Machine into Transport Position51
Conformity with the Road Regulations52
Machine Transport Using Transport Means53
Instructions for Work54
Putting the Machine into Work Position54
Adjustments in Working Position55
Cutting Height55
Ground Pressure57
Finger Conditioning Rotor Speed58
Conditioning Intensity59
Swathing and Wide Spreading60
Machine Use66
Drive Speed66
Recommendations for Uncoupling67
Optional Equipment69
Check Chains69
Lifters69
Swath Shields for Offset Swathing70
3/8 - 21 Spline Yoke70
Raised Skid Shoes Adjustable in Height70
Adjustments71
SMV Sign73
Maintenance and Storage74
Frequency Chart74
Cleaning the Machine75
Lubrication77
PTO Shafts77
Grease81
Draining82
Maintenance87
Checking the Oil Levels87
Inspection of Knives and Securing Elements88
Fitting of the Lifters98
Ground Pressure Adjustment System101
Rotor Maintenance105
Rotor Safety System106
Tyre Pressure117
Changing of a Wheel118
Storage119
At the End of each Season119
At the Start of each Season120
Storage121
Dismantling and Scrapping of the Machine121
Troubleshooting Guide122
Limited Warranty125

KUHN FC3160 TCD - Page 34

Table of Contents

Related product manuals