FC3160-3560-4060 TCD
16
4. - Safety
KN284EGB_A
Mower conditioner
4.2.6 PTO shaft
- Use only PTO shafts supplied with the machine
or recommended by the machine manufacturer.
- The protective shield of the tractor PTO stub, the
PTO shaft guards and the protective shield of the
machine input shaft must always be in place and
in good condition.
- Make sure that the PTO shaft guards are secured
with the safety chains provided. Check that the
PTO shaft guard can turn freely a full rotation
independent of the shaft.
- Any worn or damaged guards must be replaced
immediately. A worn guard or an unprotected
PTO shaft can cause a serious or even a lethal
accident.
- Do not wear loose clothing that could be caught
in the rotating PTO shaft.
- Before attaching or removing a PTO shaft, or
before doing any work on the machine,
disengage the PTO drive, turn off the engine,
remove ignition key and wait for all moving parts
to come to a complete stop.
- If the primary PTO shaft is equipped with a torque
limiter or a free wheel, these must be fitted on the
machine side.
- Ensure that the PTO shaft is always correctly
fitted and locked into place.
- Before connecting the PTO shaft, ensure that the
PTO speed (rotational frequency) and direction of
rotation are in line with the machine
manufacturer's recommendations.
- Before engaging the PTO drive, make sure that
there are no people or animals near the machine.
Never engage the PTO drive when the tractor
engine is stopped.
To Next Page
