FC3160-3560-4060 TCD
44
6. - Putting into service
KN284EGB_A
Mower conditioner
If this is not the case:
- Mark length (H) to cut when the transmission is
the maximum overlap position.
- Shorten the guard tubes and the transmission
tubes by the same length.
- Bevel and clean the tubes.
- Grease the inside of the outer tube.
Never operate the PTO shaft at an angle X
exceeding 30°.
To avoid serious accidents, the PTO drive
shaft guards must be properly in place and
fixed with the chains provided.
To Next Page
Loading...
