KUHN FC3160TCD - At the Start of each Season

FC3160TCD-3560TCD-4060TCD
124
11. - Maintenance and storage
KN284DGB B
Mower conditioner
11.5.2 At the start of each season
- Pressurize the hydraulic circuit.
- Check the condition of the friction slip clutch (see
"Secondary pto shaft" chapter).
- Inspect and replace worn knives and bolts (See
chapter: Inspection of knives and securing
elements).
- Check that all nuts and bolts are sufficiently
tightened.
- Re-read the operators' manual.
- Inspect and replace worn or damaged fingers on
the conditioning rotor.
- Make sure all the guards are in place.
- Check tyre pressure.
- Wipe off grease on cylinder rods