KUHN FC3160TCD - Knife and Securing Element Inspection

11. - Maintenance and storage
FC3160TCD-3560TCD-4060TCD
89
KN284DGB B
Mower conditioner
11.4.2 Inspection of knives and securing
elements
 Knives
Inspect systematically all knives before the machine
is operated to:
- ensure the cutting quality.
- ensure safety in use.
- Prevent cutterbar damage risks.
Replace knives in the following cases:
- Damaged knives.
• Very rough conditions can cause knives to crack
and become deformed.
- Worn knives.
Immediately replace worn or damaged parts with
genuine KUHN parts.
Knife length C must exceed 80 mm (3.15’’).
Knife width B, measured at a distance A of
10 mm (0.39’’) from the disc edge must exceed
34 mm (1.34’’).