11. - Maintenance and storage
FC3160TCD-3560TCD-4060TCD
81
KN284DGB B
Mower conditioner
11.3.3 Draining
Cutterbar
The cutterbar is lubricated for life and requires no
periodic maintenance.
If in doubt as to the oil quantity contained in
the cutterbar, fully drain and refill cutterbar
respecting recommended oil quantity and
quality.
Following all service operations or in case of
an oil leak, empty and refill cutterbar.
Before draining oil, operate the machine for a
few minutes so that the oil warms up.
FC3160TCD:
The cutterbar is lubricated with 3.5 L (0.92 US gal) of extreme-pressure gear oil with viscosity grade
ASX 75W90 and API grade GL5.
FC3560TCD:
The cutterbar is lubricated with 4 L (1.06 US gal) of extreme-pressure gear oil with viscosity grade
ASX 75W90 and API grade GL5.
FC4060TCD:
The cutterbar is lubricated with 4.5 L (1.19 US gal) of extreme-pressure gear oil with viscosity grade
ASX 75W90 and API grade GL5.
To Next Page
Loading...
