Program Edit Mode
FM Operator Page
3-91
FM Operator Page
In FM layers, the FM Operator page allows you to edit additional parameters of each FM
Operator in the layer.
Operator
Use the Operator parameter to select an Operator. e parameters for the selected Operator
are displayed.
Waveform
Use the Waveform parameter to select a waveform for the oscillator of the selected Operator.
In classic FM synthesis, sine waveforms are used. Using waveforms other than sine can be
useful for easily creating more complex timbres.
Input Source
Use the Input Source parameter to select an input for the selected Operator.
When Input Source is set to Normal, the selected Operator receives input from Operators in
the selected FM Algorithm, depending on the connections in the selected FM Algorithm.
When Input Source is set to Keymap, the selected Operator receives input from the layer’s
Keymap (selected on the Keymap page). You can adjust additional Keymap parameters on
the FM Alt Input page.
When Input Source is set to Alt, the selected Operator can receive input from another layer
in the Program. When Input Source is set to Alt, you must select a source layer by using the
Src Layer on the FM Alt Input page.
To Next Page
Loading...
