Kurzweil K2700 - The Layer FX (LYR FX) Page

Program Edit Mode
The Layer FX (LYR FX) Page
3-16
The Layer FX (LYR FX) Page
Use the Layer FX page to apply audio eects to individual layers of a Program.
Layer FX Mode
Select a Layer FX Mode to determine how eects will be applied to each layer. See below for
details on each mode:
Use Program FX
With “Use Program FX” selected, the current layer will use the eects congured on the FX
page. See The FX Page above for more information on program FX.
Layer-Specic FX
With “Layer-Specic FX” selected, you can congure the eects for the current layer. A
Program can have up to 8 Insert Chains (any combination of common and layer specic
inserts).
e Layer specic parameters are the same as on the FX page, except they apply only to the
current layer, and some of the Aux parameters are not available (the settings from the FX
page are used for the Aux 1 and Aux 2 Chain and Output parameters). See The FX Page
above for more information on these parameters.
In this mode, the Aux parameters on this page apply to the Aux Chains selected on the FX
page.
Use Another Layer’s FX
With “Use Another Layer’s FX” selected, you can put the current layer through the Insert
Chain and Aux eects settings of another layer. Use the “Use FX From Layer” parameter to
select the layer whose eects you wish to use.