Song Mode
The Save Changes Dialog
8-3
The LOCATE FORWARD Button
Press the LOCATE FORWARD button to add one Bar to the current value of the Locate
parameter.
Controlling the TRANSPORT Section with External
Sequencers
You can control the PLAY/PAUSE, and STOP buttons from an external sequencer sending
System Real-Time or MIDI Machine Control (MMC) messages. To receive these messages,
go to the Global Mode MIDI page and set the Receive Transport parameter to the desired
message type.
The Save Changes Dialog
e following dialog appears after you have recorded a track and pressed STOP.
e PLAY NEW soft button allows you to play the song with your last recorded
performance. You will likely want to hear this rst.
Pressing PLAY OLD will play the current song, minus the performance that you just
recorded. You can toggle between Play Old and Play New without restarting the song
by pressing either button while the song is playing. is is useful to check if your last
performance was better or worse than what was previously saved (if anything was previously
saved).
e Playing eld displays whether to NEW or OLD version is playing.
e Locate eld allows you choose a start time for the old or new playback. is is useful
when you just want to hear a certain part of the song without listening to the whole thing.
To Next Page
Loading...
