Kurzweil K2700 - AUDIO I;O

Global Mode
AUDIO I/O
9-27
AUDIO I/O
e Audio Input/Output page allows you to route the K2700’s analog and USB audio
inputs and outputs in various congurations to suit the needs or your recording or playback
scenario.
For details on using the front panel AUDIO INTERFACE section and rear panel AUDIO
IN jacks with various input sources, see Audio Interface on page C-1.
Synth A Dest
e “Synth A Dest” parameter determines the routing of signals set to Output A in Program,
Multi, or Song mode. By default, “Synth A Dest” is set to “Out Pair A”, so any signals set to
Output A will be routed to the rear panel analog Audio Out A jacks.
Signals set to Output A in Program, Multi, or Song mode can also be routed to USB only, or
Audio Out A jacks and USB by setting “Synth A Dest” to “USB” or “Out Pair A + USB”.
Synth B Dest
e “Synth B Dest” parameter determines the routing of signals set to Output B in Program,
Multi, or Song mode. By default, “Synth B Dest” is set to “Out Pair B”, so any signals set to
Output B will be routed to the rear panel analog Audio Out B jacks.
Signals set to Output B in Program, Multi, or Song mode can also be routed to USB only, or
Audio Out B jacks and USB by setting “Synth B Dest” to “USB” or “Out Pair B + USB”.
USB Input Dest
e “USB Input Dest” parameter determines the routing of signals received from the USB
Computer port. By default, “USB Input Dest” is set to Out Pair A, so any signals received
from the USB Computer port will be routed to the rear panel analog Audio Out A jacks.