Kurzweil K2700 - Page 150

Program Edit Mode
FM Alt Input Page
3-107
Negative Key Track values will progressively decrease amplitude for each note played above
middle C, and progressively increase amplitude for notes played below middle C. For
example, with a negative Key Track value, playing middle C causes no change in amplitude,
playing each key further above middle C decreases the amplitude by the Key Track amount,
and playing each key further below middle C increases the amplitude by the Key Track
amount.
Source 1
Use the Source 1 parameter to modulate the Alt Input source layer output level with a
physical controller or other control source.
Depth
Use the Depth parameter to set the maximum modulation depth of Source 1.
When the Source 1 control source is at its minimum value, Source 1 will have no eect on
the Alt Input source layer output level.
When the Source 1 control source is at its maximum value, Source 1 will apply the amount
of modulation set by the Depth parameter.
Source 1 control source values between the minimum and maximum will scale the amount
of modulation between no eect and the amount set by the Depth parameter.
Source 2
Use the Source 2 parameter to modulate the Alt Input source layer output level with a
physical controller or other control source.
DepthCtl
Use the DepthCtl parameter to modulate the Source 2 modulation depth with a physical
controller or other control source.
When a DepthCtl control source is at its minimum value, the Source 2 modulation depth
will be set to the value of the MinDpth parameter.
When a DepthCtl control source is at its maximum value, the Source 2 modulation depth
will be set to the value of the MaxDpth parameter.
DepthCtl control source values between the minimum and maximum will scale the Source 2
modulation depth between the values of the MinDpth and MaxDpth parameters.
MinDpth
Use the MinDpth parameter to set the minimum modulation depth of Source 2.
When a DepthCtl control source is at its minimum value, Source 2 will apply the amount of
modulation set by the MinDpth parameter.