Kurzweil K2700 - Page 171

The Effects Chain Editor
The MOD Pages
4-4
Adjust
Use the Adjust eld to set a xed value for the specied parameter. When the Control source
has a value of 0, the modulated parameter will be set to the Adjust value.
Source
e Source parameter determines the Control source that will modulate the parameter
(Param) value in real-time.
When the Source eld is selected, you can quickly assign one of the K2700’s physical
controllers (sliders, mod wheel, pedals, etc.) by holding the Enter button and moving the
desired controller. e MIDI CC number associated with that controller will be selected. You
can also enter a CC number for external MIDI control, or select one of the Chain-specic
Control sources (FXLFOs, FXASRs, and FXFUNs).
When a MIDI CC number is selected for the Source eld, a Chain info entry will be created
on the INFO page (unless that CC number is already used by another FX Mod). See the
INFO page section below for details.
If you have selected a MIDI CC number or K2700 physical controller, the FX Mod will
appear on the program Parameters page (unless that CC number is already used by another
FX Mod, in which case it will share the existing Parameter using that CC number or physical
controller). e program Parameters page allows you to set a default value for the FX Mod,
and also lets you select a dierent MIDI CC number or K2700 physical controller if desired.
is is useful for changing the control source of existing FX Mods without editing the chain.
Note: In some cases when entering a MIDI CC number, the source eld will show the
standard MIDI name associated with that MIDI CC number.
Some MIDI CCs are hard wired to control certain program parameters or functions such
as MIDI 5 (Portamento Time), MIDI 7 (Program Volume), MIDI 10 (Pan), MIDI 11
(Expression/Program Volume), MIDI 64 (Sustain), MIDI 66 (Sostenuto), so if you use one
of these numbers the CC will always perform the hard wired function, in addition to any
other assignment you make.
In Program Mode the K2700’s physical controllers each use one of the available MIDI CC
numbers, so you must choose one of the other available CC numbers when using an external
MIDI control source or else the parameter will also be controlled by a K2700 physical
controller. MIDI CC numbers associated with the K2700’s physical controllers are shown in
the list below.