Kurzweil K2700 - Page 220

Multi Mode
Save User Multis
6-12
Naming a User Multi
To rename the Multi, rst press the RENAME soft button. e display shows the current
Multi name.
Use the Category buttons, Alpha Wheel or Previous/Next buttons to change each character.
Use the Left/Right cursor buttons or <<< >>> soft buttons to move the cursor.
Press the +/- button to switch between upper and lower case characters.
Use the Insert button to insert a blank space. e selected character and all characters to the
right will move one space to the right.
Use the Delete button to delete the current character (all the characters to the right will move
one space to the left).
Saving a User Multi
Press the Save button or Save soft button to complete the saving process, or press the Cancel
soft button to exit without saving. After successfully saving, the Multi will be selected in
Multi Mode. To nd the Multi again later, press the User button and scroll to the Multi ID.
You can also type the Multi ID number, then press the Enter button.