Kurzweil K2700 - Page 245

Multi Edit Mode
CONTROLS Page
7-22
Controller
Number
Controller
Destination
Description
82 MIDI 82
Default assignment for Switch 3
83 MIDI 83
Default assignment for Switch 4
84 Portamento
Standard MIDI controller for setting Portamento starting note
85 MIDI 85
Default assignment for Switch 5
86 MIDI 86
Default assignment for Switch 6
87 MIDI 87
Default assignment for Switch 7
88 MIDI 88
MIDI Controller 88
89 MIDI 89
Default assignment for Switch 8
90 MIDI 90
Default assignment for Switch 9
91–95 MIDI 91–95
MIDI Controllers 94–95
96 Data Inc
Equivalent to pressing the Next Value button
97 Data Dec
Equivalent to pressing the Previous Value button
98 NRegParL
Non–Registered Parameter Least Signicant Byte
99 NRegParM
Non–Registered Parameter Most Signicant Byte
100 RegParL
Registered Parameter Least Signicant Byte
101 RegParM
Registered Parameter Most Signicant Byte
102–109 MIDI 102–109
MIDI Controllers 102–109
110-119 MIDI 110–119
Reserved - Not available for use in the K2700.
120 Sound Off
Stops all sound in the corresponding channel.
121 RstCtls
Resets Controllers to defaults in the corresponding channel.
122 Local
Reserved for use by MIDI specication.
123 Notes Off
Sends Note Off Message to all playing notes in the corresponding channel.
124 Poly
Reserved for use by MIDI specication.
125 Omni
Reserved for use by MIDI specication.
126 Mono On
Reserved for use by MIDI specication.
127 Mono Off
Reserved for use by MIDI specication.
128 Pitch
Values above 64 and below 64 bend the pitch up and down, respectively.
129 PitchRev
Values above 64 and below 64 bend the pitch down and up, respectively
130 PitchUp
Values above 0 bend the pitch up
131 PitchDwn
Values above 0 bend the pitch down
132 Pressure
Default Destination for Pressure
133 Tempo
Tempo
134 KeyNum
Triggers playback of notes by Key Number—e.g., C4 is 60. Send a velocity rst with
Destination 135, KeyVel.
135 KeyVel Key Velocity
136 ProgInc
Program Increment—increments current Program number.
137 ProgDec
Program Decrement—decrements current Program number.
138 ProgGoto
Go to Program—selects Program.
139 MultiInc
Multi Increment—increments current Multi number.
140 MultiDec
Multi Decrement—decrements current Multi number.
141 SetpGoto
Go to Multi—selects Multi.
145 TransUp
Transpose Up (ST)
146 TransDown
Transpose Down (ST)