KWB Easyfire User Manual

Regulating the room temperature
You can regulate the room temperature …
with a digital remote control unit or with a boil-
er control unit
with an analogue remote control unit
Specifying the room temperature
Correct the values in the menu "Room tempera-
ture" [►
23]
Main menu >> Boiler >> Room tem-
perature >> Heating circuit No.
as desired.
Use the dial to increase or decrease the set room
temperature by up to 5° C.
Specifying the heating times
If the radiators or the underfloor heating is not
warm enough at certain times, you need to
change the time period for all days ("Monday-Sun-
day") or an individual day in the menu
Main menu >> Heating circuits >>
Heating circuit No. >> Change
heating times
: Changing heating times [►
24].
—
Activating party mode
For a one-time extension of the heating time, se-
lect the "Party mode [► 23
]" in the menu
Main menu >> Party mode >> Heat-
ing circuit No.
Specify until which time the selected heating cir-
cuit is to remain at the target day temperature. Af-
ter this, the system runs normally again (normally
the night lowering usually follows).
If you set the selector switch to the "Day opera-
tion" operating mode, the heating system will heat
this heating circuit to the specified target day tem-
perature.
You will find additional information on these components in section Operating the analogue
remote control unit [► 18
].
Regulating the fuel supply
Specifying the filling times (suction systems)
In the menu Main menu >> Pellets suction system [► 38], you can change the filling
times
if the filling noise of the suction system is disturbing.
• The filling times must be at least 30 minutes long.
• Your entry will be automatically checked and corrected by the software, if necessary.
The system in the yearly cycle
Particularly in the transition periods, it is attractive to activate the Heating program [► 24
]:
(Main menu >> Heating circuits >> Heating circuit No. >>
Heating program)
• In the autumn, switch to "Transition", and only later to "Heating program 1" or "Heating pro-
gram 2".
• In the spring, you should switch back to "Transition" and later to "Off".
3.4
3.5
3.5.1
3.6
Operating fundamentals
3
Regulating the room temperature
B KWB Easyfire EN, 05.2011
15

KWB Easyfire Specifications

General

Fuel Type	Wood pellets
Cleaning System	Automatic heat exchanger cleaning
Emission Class	5
Nominal Heat Output	10 kW
Type	Pellet heating system
Ash Removal	Automatic
Heating capacity	10 kW
Hopper capacity	15 kg
Flue diameter	130 mm