Operating the analogue remote control unit
Analogue remote control unit
If your system is equipped with a weather-sensitive heating circuit control system
, you can
control individual heating circuits with an analogue remote control unit depending on the room
temperature.
You can use the dial on the analogue remote control unit to change the desired room tempera-
ture. At the “+” stop, the room temperature is increased by 5 °C, at the “-" stop, it is lowered
by 5 °C. Please observe that the "Room temperature" value in the boiler control unit remains
unchanged.
The following modes can be set on the selector switch of the analogue remote control unit:
Analogue remote control unit operating modes
Standby mode
The heating circuit is switched off in this mode. However the frost protection function is active.
The boiler must be switched on for this (section "System On / Off").
Night mode
The heating circuit is always maintained at the set night lower temperature.
Automatic mode
The heating circuit is operated according to the set time program, i.e. within the set heating
times at day temperature - except at night lower temperature where it is held or shut off.
Day mode
The heating circuit is always maintained at the set day temperature.
4
4
Operating the analogue remote control unit
18
B KWB Easyfire EN, 05.2011
To Next Page
Loading...
Need help?
General
